3 Waves Cold Rolled Steel Silo Forming Machine With 17 Forming Stations

3 Waves Cold Rolled Steel Silo Forming Machine With 17 Forming Stations

1. Show of the equipment

(the thickness of sheet: 2-3.5mm)

Uncoiler - Feeding (take the sheet to the first station) - Leveling - Punching of the sheet - Roll forming - Hydraulic cut to length - Product packing manual

2. The structure of equipment

● Hydraulic uncoiler
a. Single unrolling machine, one side can put material
b. Adopt automatic hydraulic system
c. Maximum coil weight: 7000kg
d. Maximum coil width: 500mm

● Feeding & leveling
a. Feed into unit oriented wheel (can right and left adjust)
b. Into feeding roller diameter is 180mm, material is 45# steel, quenched 48°-52°, chromed
c. Leveling is three rollers above and four rollers below, quenched and chromed

● Punching (can right and left adjust)
a. Using hydraulic punching
b. Working pressure: 20mpa
c. Mold material: Cr12 quenched 58°-62°
d. Hydraulic power: 7.5kw
e. Size:1500*1100*1200mm (Length*Width*Height)

● Roll forming machine
a. Main motor power: 45kw
b. Drive: gearbox driving,120*500
c. Main shaft diameter: 100mm and 45# steel
d. Roller material: GCR15 quenched 58°-62°, chromed
e. Roll station:17 stations
f. Timing by transducer: 5-20m/min (not including punching)

● Cutting unit
a. Hydraulic cut
b. Knife material: Cr12, quenched 58°-62°
c. Oil cylinder diameter: 250mm
d. Working pressure: 30mpa
e. Working journey: 80mm

● The Outside size
a. 18000*2200*1500mm (Length*Width*Height)

● Output table
a. Jointed by 60*40mm tube (can be adjusted to up and down)
b. size:1500*800*600-1000mm (Length*Width*Height, can be adjusted)

● Control panel-Panasonic
a. Control system
- voltage, frequency, phase: 380V, 50HZ, 3Phase
- automatic length measurement: one unit tooling of length measuring which is lightly pressed on the surface of the steel sheet; the tolling will roll with the moving speed of the steel sheet and then sense to measure its length.
- automatic quantity measurement
- computer used to control length & quantity, machine will automatically cut to length and stop when required quantity is achieved
- length inaccuracy can be amended easily
b. Control panel: button-type switch, LED display length and quantity
c. Unit of length: millimeter and inch (switched on the control panel)
d. Protection function
- motor over: load protection
- system over: current protection
- short circuit protection
e. Additional function
- display total length produced
- display total quantity produced
- display forming speed